Cabling Information - Alphanumeric Displays to NTD Clock
We offer the following cables that are suitable for connecting the time code signal from one component to another. The cable is shielded RG-58 coax (1/4" - .63cm diameter) with dual BNC connectors. It is available in the following lengths:
Part Number |
Length |
|
CC10 |
10' - 3m |
|
CC25 |
25' - 7.6m |
|
CC50 |
50' - 17m |
|
CC100 |
100' - 30.5m |
Custom lengths can also be supplied - contact factory with requirements.
** Note that this cable cannot be used with the GPS antenna **
Interconnecting Cable - GPS200 to TCO100 |
|
Part Number is TCO100CC |
|
|
Wiring Diagram
|
BNC to Twisted Pair Adapter |
|
BNC Male, 6"/15cm leads with tinned end. |
|
Allows twisted pair wire to be connected to BNC connectors |
RC200 Remote Control - Optional Cable and Adapters
RJ12M-RJ12M, 6P6C, 6 Conductor Cable
Part Number |
Length |
|
CCRJ12-50 |
50' - 15m |
|
CCRJ12-100 |
100' - 30m |
|
CCRJ12-250 |
250' - 76m |
|
CCRJ12-500 |
500' - 152m |
DB9F to RJ12F RS485 Cable Adapter for TCD series II clock |
|
Part Number: CA485 |
RJ12M single port to RJ12F 6P6C multiport adapters, 6 conductor |
|
Part Number: CARJ12-6C2 |
Part Number: CARJ12-6C5 |
|
Optional power cords for analog clocks |
|
DB-9 and DB-15 to BNC adapters allow the inputs and outputs of various Masterclock® products to be connected via coaxial cable and BNC connectors. Any type of coaxial cable can be used in this application. The table below shows where a BNC adapter can be used. Note that these adapters are normally supplied with the appropriate products, however they can also be purchased separately.
Product |
Input Connector |
Output Connector |
Adapter To Use |
GPS200A |
BNC |
DB-9 Male |
BNC9 |
TCI232 |
BNC |
DB-9 Male |
BNC9 |
TCI232A |
BNC |
DB-9 Male |
BNC9 |
TCI500 |
BNC |
DB-9 Male |
BNC9 |
TCG100 |
BNC |
DB-15 Female |
BNC15 |
TCR500 |
DB15 Female |
BNC15 |
|
TCO100 |
DB-9 Male** |
DB-9 Male |
BNC9 |
**TCO100CC would normally be used.
